9711 C & Ku-Band TXRX
Installation
3-5
17.
Remove the feed assembly from its box. If
more than one feed is provided with your
system only un-package the feed which will
be first used after the ADE is completely
assembled.
18.
Assemble the Feed Assembly to the feed
struts, aligning the labels on the end of the
feed strut to the label on the feed assembly.
19.
Keep the assembled reflector/feed assembly
mounted on the reflector support structure
until you are ready to install it on the
Pedestal.
20.
Keep any additional Feed assembly(ies) in
this area with the reflector.
21.
Keep the Waveguide box in this area until
you are ready to install the reflector on the
Pedestal.
Note: You will install the reflector later in the
installation instructions.
3.3.
Assembling the ADE
3.3.1.
Preparing for Assembly of the ADE
Read this entire assembly procedure before beginning.
Refer to the System Block diagram, General Assembly, Baseframe Assembly, Radome Assembly and Radome
Installation Arrangement drawings for your system.
Select a secure assembly site that provides enough area to work with the large radome panels while sub-
assembling the baseframe, sections of the radome, Antenna Pedestal and Reflector & Feed. The area should
be a clean, flat location, free of rocks & debris (ie concrete). The site should also provide protection from
wind, rain and other adverse weather. A hoist, or small crane, is needed to assemble these sub-assemblies to
form the final ADE Assembly.
As an example, you might sub-assemble everything on the pier where the ship will tie up, then use the crane
to put the sub-assemblies together and lift the whole ADE up to the mounting location on the ship.
You can change order of these steps, however, in the end the objective is to have a well sealed
radome with flanges that are clean of excess caulking. In addition it is important that the ADE is
structurally sound for severe weather conditions.
3.3.2.
Sub-assemble the Base Frame Assembly
Refer to the Base Frame Assembly drawing for your system and the procedure below.
NOTE: Unless otherwise indicated, all nuts and bolts should be assembled
with Loctite 2760 or its equivalent.
Summary of Contents for 9711 C
