9711 C & Ku-Band TXRX
Installation
3-13
4.
Use wedges to lift the lower
panel assembly up off of the
riser panels about ½ inch.
5.
Install a good bead of
caulking between the bottom
of the lower panels and the
base frame (smaller dual
beads of caulking can be
applied from outside and
inside if you prefer) , remove
the wedges, apply Loctite to
and then firmly tighten all of
the horizontal seam bolts.
6.
Clean excess caulking off
inside and outside of the
radome.
7.
Remove tape from the
horizontal edges of the lower
panels.
The bottom half of the radome is
complete. Next you will assemble
your antenna pedestal General
Assembly and install it into this
portion of the radome, before
putting the top half of the radome
on.
3.3.6.
Installing the Marine Air Conditioner
If a marine air conditioner was purchased with your system:
1.
Set the marine air conditioner on the base pan aligning the vents in the bottom of the air
conditioner to the cutouts in the basepan (refer to drawing 123496).
2.
Install the air, per drawing 122508, using the hardware and isolators provided in the installation kit.
3.
Install the strain reliefs as required to install AC power cable to the air conditioner.
3.3.7.
Installing the Ku-Band Co-Pol/Cross-Pol Feed Assembly
Refer to the procedure below to install the Ku-Band Co-Pol/Cross-Pol feed assembly on the 2.m meter offset
reflector.
1.
Assure that the DAC-2202
System Type does NOT
include 8.
2.
Assure that the DAC-2202 TX
Polarity is set to 2 (Horizontal
TX).
3.
If this is the initial installation
of a drop-in feed, skip to step
12.
4.
If switching drop-in feeds,
remover the currently
installed drop-in by following
step 5-10.
Summary of Contents for 9711 C
