Sea-doo 210 Challenger, Operator'S Manual

Page: 79 / 168

EQUIPMENT
lbg2010-003-007_a
1. Receptacle cap removed for ski pole
installation
Insert the ski pole with the grooved
end up.
Push the ski pole down into the re-
ceptacle until the shoulder portion sits
flush on the receptacle and ensure it is
properly locked in the receptacle.
lbg2010-003-009_b
SKI POLE INSTALLED
1. Ski pole warning label
SKI POLE WARNING LABEL
WARNING
– Completely remove
ski pole when not used.
– Make sure ski pole is
locked into base before use.
– Maximum gross weight 225 kg
(500 lb).
NOTE: The ski pole is equipped with
spring loaded locking pins that engage
a groove within the ski pole recepta-
cle. When the pin locks engage, you
should feel and hear them
"click" in the
groove.
lbg2010-003-038_a
1. Ski pole shoulder
2. Spring loaded locking pins (2)
The ski pole may now be used for tow-
ing a tube, water skier, wakeboarder or
for mounting the table.
WARNING
– Always ensure the ski pole is
properly locked in the recepta-
cle before use.
– Always have an observer watch
the tube, water skier or wake-
boarder.
– Never use the ski pole for any
other application than the one it
has been designed for:
example; Never use to tow any
other watercraft
– Never exceed the load limit rat-
ing of the ski pole, maximum
gross weight of 225 kg (500 lb).
Overloading can affect maneu-
verability, stability and perfor-
mance, or cause damage.
– Remove and properly store the
ski pole when it is not being
used to prevent possible injury.
_______________
77