Sea-doo 210 Challenger, Operator'S Manual

Page: 44 / 168

PRE-RIDE INSPECTION
Fuel
Make sure you have enough gasoline.
Fill the fuel tank, as needed.
WARNING
Strictly adhere to instructions in
the
FUELING PROCEDURE
.
Hull
Walk around your boat inspecting the
hull for cracks or other damages.
Jet Pump Water Intakes
Remove weeds, shells, debris or any-
thing else that could restrict the flow
of water and damage the cooling sys-
tems or propulsion units. Clean as
necessary. If any obstruction cannot
be removed, refer to an authorized
Sea-Doo Boats dealer for servicing.
lmo2010-003-010_a
1. Inspect this area
Inspect leading edges of the impellers,
for nicks or bends, which greatly re-
duce performance of the boat.
Bilge
WARNING
Check for abnormal water pres-
ence in bilge. Make sure drain plug
is properly secured before launch-
ing the boat in water.
Engine Compartment
Ensure that the engine compartment
is free of gasoline vapor odors and vi-
sually, inspect fuel lines for deteriora-
tion and the condition of the fuel tank
straps and theirs fasteners.
NOTE: The engine cover latch handle
is located under the stern central cush-
ion.
lmo2010-003-105_a
1. Location of the engine cover latch handle
WARNING
If any leaks or gasoline vapor
odors are present, DO NOT start
engines or use electrical acces-
sories.
Consult an authorized
Sea-Doo Boats dealer.
Main Battery Cut-Off
Switch
Turn switch in the ON position to allow
starting engine and use accessories.
lmo2010-003-119_a
MUST BE GREEN WHEN ON
1. ON position
42
_______
SAFETY INFORMATION
________