Sea-doo 210 Challenger, Operator'S Manual

Page: 114 / 168

MAINTENANCE PROCEDURES
NOTICE
Always close the water
tap before stopping the engine.
NOTICE
Remove quick connect
adapter after flushing operation (if
used).
Fuses and Circuit Breakers
The electrical system is protected with
fuses and circuit breakers.
To remove fuse from holder, pull fuse
out. Check if filament is melted.
1
2
A15E0KA
1. Fuse
2. Check if melted
If a fuse is defective, replace by one of
the same rating.
NOTE: If the entire electrical system
is down, make sure the main battery
cut-off switch is properly turned on,
refer to
EQUIPMENT .
NOTICE
Do not use a higher rated
fuse as this can cause severe dam-
age. If a fuse has blown, the source
of malfunction should be deter-
mined and corrected before restart-
ing.
See an authorized Sea-Doo
boats dealer for servicing.
Vehicle Control Module (VCM)
Fuses
Each engine has its own fuses box.
Both fuse boxes are located on the aft
transom.
Refer to the fuse cover decal or the
SPECIFICATIONS
section for fuse
identification.
lmo2010-003-106_a
1. Fuse box
To remove a fuse cover, unlock the tabs
and pull cover off.
Use the cover built-in fuse puller to pull
fuses out.
F06H1TY
1 2
TYPICAL
1. Cover
2. Fuse puller
Circuit Breaker Panel
The circuit breaker panel is located un-
derneath the driver console.
Refer to the inscriptions on the panel
for circuit breaker identification.
112
______________