Page 5
HYDR
IM
C51wd Service Guide
1. Introduction
1.4 Tools & Hardware
The unit contains the following types of hardware:
•
Phillips pan head self-tapping metal screws
•
Phillips flat head stainless steel machine screws
•
Torx pan head machine screws
•
Torx pan head plastite screws
1.5 Shipping Instructions
The unit should be serviced on site. If it is necessary to send the unit back to the dealer,
follow these instructions. Before shipping the unit, run the drain pump to remove most of
the water from the system. If there is standing water in the chamber, siphon or ladle as
much water as possible and use an absorbent cloth to remove the rest.
Disconnect and remove the cleaning solution container and then drain the dosing
reservoir.
Completely screw in the levelling legs. Specify upright, heated, and insured
shipping.
DESCRIPTION
1. Nose pliers
2. Screwdriver PH1
3. Screwdriver PH2
4. Screwdriver Slot
5. T20 Torxdriver
6. Dental Wedge
7. Wire stripper
DESCRIPTION
8. Wire cutter
9. Small screwdriver
10. Nut driver
1
/
4
"
11. Nut driver 5.5 mm
12. Nut driver 7 mm
13. Nut driver 8 mm
14. Nut driver 13 mm
DESCRIPTION
15. Wrench
7
/
16
"
16. Wrench
1
/
4
"
17.
11
/
16
"
socket
18. Allen key 2.5 mm
19. Mallet
20. Tension Gun
Reporting
•
It is vital for SciCan to learn of any problem in the field. This information will help
SciCan solve the problem quickly and improve product reliability in new units.
Biological waste
•
Waste water in the unit may contain biological contaminants; use a mechanical
means to siphon the contents. Wear disposable rubber gloves. Dispose of
absorbent material according to biological waste disposal regulations.
