4.2 Removing The Top Cover
To remove the top cover, follow
these steps:
1.
Power OFF the unit, and
unplug.
2.
Remove the 4 Phillips
screws that hold the filter
cover in place (Figure 16a).
3.
Remove the screws that
secure the top cover:
•
2 screws and white caps on
the right side of the cover (Figure 16a).
•
2 screws and white caps on the left of
the cover (not shown).
•
7 Phillips washer screws on the back
of the cover: (1 on the top, 3 on the right,
3 on the left.) (Figure 16b)
•
6 Phillips flat head machine screws
on the inside front of the unit (4 on the
top, 2 on the left) (Figure 16c). The two
screws on the right side do not secure
the top cover and do not need to be
removed.
4.
Grasp the left and right sides of the cover.
Pull sides slighty outward and lift straight up.
5.
Remove the insulation on the top and sides.
6.
When replacing the cover, ensure that the orange cap for the screw under the drip
tray is replaced (Figure 16d).
4. Unit Overview
Rear Of The Unit
7 Phillips screws
6 Phillips screws
4 filter
cover
screws
2 screws
and
caps
Figure 16a
Figure 16b
orange cap
Figure 16d
Figure 16c
Page 14
HYDR
IM
C51wd Service Guide
