Installation
18
02.01|FDB 150, 300, 340, 660, 900, 1040 |en
Installation
The FDB Deburring Spindle is delivered fully assembled. Optional
equipment such as: mounting adapter plates, burrs, and additional
collets will be separate.
Inspection of Condition When Delivered
Upon receipt, the following should be checked:
• Delivery in accordance with freight document
• Damage to packaging
• If there is damage to any of the packaging, or if any of the
goods have been exposed to abnormal handling, unpack those
parts that may have been damaged for a closer inspection. If
necessary, notify SCHUNK for assistance in evaluation of the
product condition.
Unpacking and Handling
The FDB Deburring Spindle should always be placed inside the ac-
companying box (crate) during transportation, storing and han-
dling.
Pneumatic lines and electrical cables are attached, bundled, and
must be strain-relieved in a manner that allows for freedom of
movement during operation.
Mounting
The FDB is capable of rear (axial) or side (radial) mounting.
SCHUNK offers a blank rear interface plate kit for rear mounting
and a simple foot bracket for bench mounting.
NOTICE
When using the side mounting pattern, the mounting screws
must not exceed maximum depth from the mounting surface
into the housing.
If screws extend past the maximum depth, they can interfere
with the free compliance of the tool. Use proper length screws
with the side mounting pattern, refer to the catalogue for further
details of the mounting features and requirements.
The FDB must be rigidly mounted using either of its mounting sur-
faces prior to use. Under no circumstances should the unit be used
5
5.1
5.2
5.3
