12
Special Accessories
Cross cutting jig
7312 0025
Circular cutting device
Bit stop
}
7319 0710
Grinding belt device
Underframe for tables
7319 0709
Automatic starter, type ALV 2
7910 4010
Type ALV 10
7910 4020
Saw bands
for wood:
12/0.5/2360 mm, 4 teeth/inch
7319 0701
Standard saw band
15/0.5/2360 mm, 4 teeth/inch
7319 0704
Straight upright cuts with longitudinal stop
for wood and synthetic materials:
6/0.5/2360 mm, 6 teeth/inch
7319 0702
Turning works with small radius 25 mm
12/0.5/2360 mm, 6 teeth/inch
7319 0705
Precision cutting works
Different materials:
wood, synthetic materials, metals
3.5/0.5/2360 mm, 14 teeth/inch
7319 0706
Extra-fine cutting works, extremely small radiuses
Non-ferrous metals up to 10 mm
6/0.65/2360 mm, 22 teeth/inch
73190707
straight cuts and turning works
Synthetic materials, non-ferrous metals
6/0.65/2360 mm, 10 teeth/inch
73190703
Synthetic materials, non-ferrous metals above 15 mm
12/0.65/2360 mm, 10 teeth/inch
73190708
straight cuts and large radiuses > 60 mm
Troubleshooting
Failure
Possible cause
Solution
Saw blade gets loose after
a) Fastening nut tightened
a) Tighten fastening nut, M20 left-handed thread
turning off the motor
insufficiently
Motor does not start
a) Fastening nut tightened insufficiently a) Check the mains fuse.
b) Extension cable defect
b) See “Electrical Connection” in the operating
manual, pages
GB 11
c) Connections on the motor or
c) Have it checked by an electrician
switch defect
Brake does not bleed
d) Motor or switch defect
d) See “Electrical Connection” in the operating
manual, pages
GB 11
Motor runs forward or
Capacitor defect
Have it exchanged by an electrician
backwards
No motor output
Overload by dull saw
Insert a sharpened saw blade; motor can be
turned on again
turns off automatically
blade, thermoprotection is triggered
after the cooling period
Burns on the cutting
a) Fastening nut tightened insufficiently a) Insert a sharpened saw blade
surface
b) Wrong saw blade
b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) with longitudinal cuts
c) Longitudinal stop not parallel
c) Exchange the longitudinal stop
d) with cross cuts
d) Slide carriage not parallel
Align the slide carriage with the saw blade
