7
PART#-31600035-LIT-SXD2110-MANUAL-REV.A
FIG. E
3. After mounting the Collector & Bottle assembly, the tubing must be connected to the
collector.
•
To ensure that no dust or debris is in tubing, turn the control unit on to blow air
through the tubing, then turn the control unit off.
•
Cut the 1/4in. Air Supply Tube from the control unit to length and press into the
quick disconnect fitting.
•
Locate the plastic barbed fitting and connect to quick disconnect fitting on collector
assembly.
•
Cut the 3/8in. Output Tube to length and attach to the barbed fitting on the
collector.
NOTE: Make sure that the tubing descends gradually to the collector. Flat areas or
“catches” will cause the system to build up excess oil in the tubing and interfere with
proper operation.
NOTE: If more than one nozzle/bottle is used, split the 1/4in. air input tube from pump
by using the supplied 1/4in. “Y” quick disconnect fitting.
FIG. F
FIG. F
AIR DUCT
CONTROL UNIT
OUTPUT TUBE
COLLECTOR &
BOTTLE ASSEMBLY
DUCT INPUT ASSEMBLY
AIR SUPPLY TUBE
1/4in. Air Supply Tube
Barb Fitting
Quick Disconnect Fitting
3/8in. Output Tube
Collector
Quick Disconnect Fitting
Bottle
Check Valve
White Bottle Seal
OPTIONAL SECOND
COLLECTOR &
BOTTLE ASSEMBLY
1/4IN. “Y” QUICK
DISCONNECT FITTING
