5
PART#-31600035-LIT-SXD2110-MANUAL-REV.A
4. Use the provided zip tie with screw mount to secure power supply and excess wire to the
wall.
5. Connect the 3 wire power cord to the ScentStream™ 12V power supply, and then plug
the cord into an AC supply outlet. Plug the power adapter into the DC POWER IN hole
on the side of the ScentStream™ unit.
6. For AIR OUT fitting, use provided 1/4” OD x 0.180” ID Nylon tubing maximum of
25ft./7.62m in length.
•
If needed use 1/4” retaining clips to secure tubing to wall attaching with
appropriate hardware. This will help prevent damage to the tubing.
•
Attach the 1/4” air supply tubing to the control unit by pressing a cleanly cut end
of the tubing straight into the elbow fitting on the side of the unit. Then pull back
slightly to check that the tubing is locked in place. To remove the tubing from these
quick disconnect fittings, just push the collar of the fitting down and pull the tubing
straight out.
FIG. B
1/4in. Air Supply Tube
Output Elbow Fitting
DC Power In
FIG. B
FIG. C
View From Inside Duct
Duct Assembly Mounting Preparation
1. Insert the 3/8in. output tubing through the grommet on the duct input assembly.
2. Using the provided zip ties, attach the final 1ft. of the output tubing to the directional
output mounting assembly.
3. Bend the long end of the rod in the direction of air flow and slightly up. Bend so that tip
reaches to the center of the duct or as close as possible.
NOTE: Before inserting into duct, ensure that the completed assembly is on a constant
ascent, with no dips and the nozzle close to the center of the air duct. Be sure not to
kink the tubing.
FIG. C
CONTROL UNIT
