Carefully wipe dry the door gasket, clean the groove using a wooden chopstick
wrapped with cotton string. After the cleaning, fix the four corners of the door
gasket first, and then embed it segment by segment into the door groove.
Interruption of power supply or failure of the refrigerating system
• Take care of the frozen foods in the event of an extended non-running of the
refrigerating appliance (such as interruption of power supply or failure of the
refrigerating system).
• Try to open the freezer door as less as possible, in this way can food safely
and freshly kept for hours even in hot summer.
• If you get the power outage notice in advance
:
1) Adjust the thermostat knob to the high mode an hour in advance, so that
foods get fully frozen (Do not store new food during this time!). Restore the
temperature mode to the original setting when power supply becomes nor-
mal in a timely manner.
2) You can also make ice with a watertight container, and put it in the upper
part of the freezer, so as to extend the time for fresh food to be stored.
Note:
Once the freezer is used, you’d better use it continuously; and under nor-
mal circumstance, do not stop its use, so as not to affect the service life.
Safety-check after maintenance
• Is the power cord broken or damaged?
• Is the power plug firmly inserted into the socket?
• Is the power plug abnormally overheat?
Note:
Electric shock and fire accident may be caused in case the power cord and
plug is damaged or stained by dust. If any abnormality, please unplug the power
plug and get in contact with the vendor.
How to disassemble the parts.
Shelf:
Hold one end of the shelf, and lift it up while pulling it outward.
Flip cover:
Keep the flip cover in the vertical direction, align it with the rotating shaft opening
on the right side, and pull it outward to remove it;
During use of the freezer, do not close the door when the flip cover is opened, to
avoid damaging the freezer door!
Simple fault analysis and elimination
(varying with different products)
With regard to the following small faults, not every failure needs to be fixed by the
technical service personnel; you can try to solve the problem.
Completely non-refrigeration
• Is power plug off?
• Are breakers and fuses a broken?
• No electricity or line trip?
• Re-plug.
• Opening the door and checking whether the lamp is lit.
Abnormal noise
• Is freezer stable?
• Does freezer reach the wall?
• Adjusting freezer’s adjustable feet.
• Off the wall.
。
Poor refrigerating efficiency
• Do you put hot food or too much food?
• Do you open the door frequently?
• Do you clip food bag to the seal of door?
• Direct sunlight or near a furnace or stove?
• Is it well-ventilated?
Temperature setting in too high?
• Putting food into freezer when hot food becomes cool.
• Checking and closing the door.
• Removing the freezer from the heat source.
• Emptying the distance to maintain good ventilation.
• Setting to the appropriate temperature.
Peculiar smell in freezer
• Any spoiled food?
• Do you need to clean freezer?
• Do you pack food of strong flavors?
• Throwing away spoiled food.
• Cleaning freezer.
• Packing food of strong flavors.
Buzzer alarm
• Is there any door opened?
• Open the door, and close it again.
All indicator lights on the display panel ON
• Is the defrosting function enabled?
• Hold down the SET key for 3s (for details, refer to the Functions section
about Defrosting)
Note:
If the above descriptions are inapplicable to troubleshooting, do not disas-
semble and repair it yourself. Repairs carried out by inexperienced persons may
cause injury or serious malfunctioning. Contact the local store where your pur-
chase was made. This product should be serviced by an authorized engineer and
only genuine spare parts should be used.
When the appliance is not in use for long periods, disconnect from the electricity
supply, empty all foods and clean the appliance, leaving the door ajar to prevent
unpleasant smells.
Certifications
Electrical information
This electrical appliance must be grounded.
This product is equipped with a plug, which is suitable for all houses equipped with
sockets meeting the current specifications
If the fitted plug is not suitable for your socket outlets, it should be cut off and
carefully disposed of. To avoid a possible shock hazard, do not insert the discarded
plug into a socket.
This product complies the EEC directives.
Disposal
Old appliances still have some surplus value. An environmentally friendly ap-
proach will ensure that valuable raw materials are recycled.
The refrigerants used in your equipment and insulation materials require special
handling procedures. Make sure there is no pipe damage on the back of the
equipment before handling.
Up-to-date information on the options for disposing of old equipment and pack-
aging from old equipment can be obtained from the local municipal office.