Page 30/70
| May 2015 | 2.0
Tap on
Next step
.
Select the reference line (field boundary) parallel
to which the operation has to be performed.
Select the desired drive mode (straight, curved or
contour) and use the arrows to the left and right of
the word
Reference line
to select the desired
reference line. The selected reference side is
highlighted green (Figure 32).
Please note!
Straight lines shorter than 20 metres in
length cannot be selected for defining an
operation.
Please note!
If two straight lines at the opposite sides of
the field run more or less parallel, only one
of the two lines can be selected for defining
an operation.
Tap on
Next step
. If desired, change the
operating width
of the operation. If necessary,
also change the
spraying width
.
The input field
Spraying path offset
is used to
enter the distance between the defined field
boundary and the first spraying track. This is
normally half the spraying width (for a spraying
width of 15 metres, i.e. 7.5 metres).
Figure 32 Defining an operation - step 2
Figure 33 Defining an operation - step 3