Savant IP Audio Deployment Guide
Copyright © 2017 Savant System, LLC
009-1551-00 | 171121
9 of 34
Rear Panel
Speaker
Connections
(4) Speaker output zones.
Uses 4-pin Speaker Connectors.
NOTE
: Compatible with 8 ohm or 4 ohm speakers.
Digital Audio Out
(1) Digital optical preamp output,
line-level 96kHz/24-bit output, fixed volume.
Digital Audio In
(2) Digital optical audio inputs.
Supports up to 96kHz/24-bit digital audio in; PCM stereo format only.
Analog Preamp
Output
(1) Analog stereo line output (Left & Right).
Direct Line Level 2.1-V
RMS
Output.
Analog Input
(2) Analog stereo inputs (Left & Right),
RCA line-level inputs; 22 k
Ω
input impedance.
Ethernet
8-pin RJ-45 port
10/100/1000 Base-T auto-negotiating port. Supports Audio Video Bridging (AVB).
Activity LED
:
Green Blinking: Activity (Rx/Tx)
Off: No Activity
Link LED
:
Green Solid: Ethernet Link is established (any speed).
Off: Ethernet link is not established.
IR
(6) IR Ports
Uses 6-pin IR Connectors to send IR signals to control devices with an IR input or IR receiver via an IR flasher (5V tolerant only).
See IR Wiring section for important precautions regarding IR functionality before making any connections.
Relay
3-pin Control Connector.
See Relay Wiring for pinouts.
Normally Open (NO) Normally Closed (NC) to control devices requiring basic on/off operation. DC Voltage Max: 30V DC 1A.
GPIO
3-pin Control Connector
See GPIO Wiring for pinouts
GPIO Input
: When configured as an input the processor will look for a low (<0.8V DC) or a high (>2.4V DC) state. Minimum 0V DC
/ Maximum 12V DC.
GPIO Output
: When configured as an output, the port provides a binary output of 0-12V DC 150mA max.
RS-232
8-pin RJ-45 port used to transmit and receive serial binary data to and from serial controllable devices. CTS/RTS handshaking
availability based on component profile. See RS-232 Connections section for pin-outs.
USB
USB 2.0 Type A (reserved for future use)
Power Input
100/240V AC (50/60 Hz) 5.7A
Fuse
: 250V 10A slow blow fuse; field replaceable
I/O
(power switch):
I (On): Powers On the chassis.
O (Off): Powers Off the chassis.
