Savant IP Audio Deployment Guide
Copyright © 2017 Savant System, LLC
009-1551-00 | 171121
29 of 34
Appendix A: Network Requirements
Savant requires the use of business class/commercial grade network equipment throughout the network to ensure the reliability of communication
between devices. These higher quality components also allow for more accurate troubleshooting when needed.
Device Network Connections
Connect all Savant devices to the same local area network (LAN) or subnet as the host. Savant recommends not implementing any type of traffic or
packet shaping in your network topology for the Savant devices as this may interfere with performance.
AVB Requirements
Savant requires a AVB/TSN Compliant Switch. The AVB/TSN switch should be an extension of the current network.
Managing IP Addresses
To ensure that the IP Address will not change due to a power outage, a static IP Address or DHCP reservation should be configured. Savant recommends
using DHCP reservation within the router. By using this method, static IP Addresses for all devices can be managed from a single UI avoiding the need to
access devices individually.
Setting a Static IP Address
Refer to the
Appendix C
.
Setting DHCP Reservation
Setting DHCP reservation varies from router to router. Refer to the documentation for the router to configure DHCP reservation.
Network Changes
Savant recommends performing one of the following steps to refresh the IP connection after connecting to a new network, changing routers, or if the IP
Address range is changed in the current router. This will reset any IP connection and ensure that the host is communicating with the network correctly.
–
Cycle Power
–
Disconnect the Pro Audio 4 from the power source.
–
Wait 15 seconds and then reconnect.
–
Hot Plug the Ethernet (LAN) Connection
–
Disconnect the Ethernet (LAN) connection from the controller.
–
Wait 15 seconds and then reconnect.
