Savant IP Audio Deployment Guide
Copyright © 2017 Savant System, LLC
009-1551-00 | 171121
15 of 34
4.8.
Checking and Replacing the Fuse
ELECTRIC SHOCK HAZARD
:
Disconnect the unit from AC power by removing the power cord from the AC outlet and the unit before replacing the fuse.
IMPORTANT
:
The orientation of the cartridge within the unit and location of the fuse within the cartridge are crucial to proper operation. Make note of the orientation
of the cartridge and the fuse location within the cartridge before removing.
1.
Disconnect the unit from AC power by removing the power cord.
2.
Open the fuse cover on the AC power input using a flat head screwdriver or similar thin flat head tool. This will allow access to the fuse
cartridge.
3.
Using a flat head screwdriver or similar thin flat head tool, gently loosen the cartridge and pull the cartridge out of the unit slowly. As the
cartridge is removed, make note of the orientation, as it is important to proper operation.
TIP
:
Mark the chassis and fuse holder with a marker in order to align when replacing.
4.
Remove the old fuse from the cartridge and discard.
5.
Gently place the new fuse in the cartridge and place the cartridge part way into the receptacle aligning it as defined in the diagram.
6.
Gently press on the cartridge the rest of the way until it seats into the terminals at the rear of the slot.
NOTE
:
If any resistance is encountered during seating the cartridge, DO NOT apply more pressure. Stop pressing on the cartridge, remove it, verify the
orientation, and repeat step.
A
B
Connection Pins Towards Unit
Open Side of Cartridge Towards Power Switch
A
B
