Savant IP Audio Deployment Guide
Copyright © 2017 Savant System, LLC
009-1551-00 | 171121
11 of 34
3.5.
PAV-AOM8C
Front Panel
Power LED
Green
: System has power and is operating
normally.
Off
: System is not receiving power.
Status LED
Off
: Embedded processor is resetting, or is powered up, and is booting the embedded firmware.
Green
: Host has established communications with the embedded system.
Green Blinking
: Embedded system is ready, but no communication has been established with the host.
Red
: Host has determined the firmware needs to be updated, but a problem occurred during the process that will initiate a
reset.
Red Blinking
: Embedded firmware is running, but has not received a DHCP IP Address.
Amber
: Host is updating the embedded firmware.
Amber Blinking
: Embedded system has a valid link-local IP Address and is connecting to the host.
Rear Panel
Reset
Resets the network settings of the device. Hold Reset Button for 5
seconds while powered on to clear network settings. Status LED will
rapidly blink red when reset is complete.
USB
USB 2.0 Type A (reserved for future use).
GPIO
3-pin Control Connector
See GPIO Wiring for pinouts
GPIO Input
: When configured as an input the processor will look for a low (<0.8V DC) or a high (>2.4V DC) state. Minimum 0V DC
/ Maximum 12V DC.
GPIO Output
: When configured as an output, the port provides a binary output of 0-12V
DC 150mA max.
RCA Output
(8) Analog stereo line output (Left & Right)
Direct Line Level 2.1-V
RMS
Output
Ethernet
8-pin RJ-45 port
10/100/1000 Base-T auto-negotiating port with Link/Activity LEDs.
Supports Audio Video Bridging (AVB).
Ethernet
Activity LED
Green Blinking
: Activity (Rx/Tx).
Off
: No Activity.
Ethernet
Link LED
Green Solid
: Ethernet Link is established.
Off
: Ethernet link is not established.
Power Input
5V DC 3A
