Version 1.0
[
65
]
SAV 220.76 /SAV 242.92 /SAV 243.70 /.71 /
SAV 243.72 /.73 /.76 /.77 /.78 /.79 /.80 /.99
Version 1.0
[
65
]
EN
SAV 220.76 /SAV 242.92 /SAV 243.70 /.71 /
SAV 243.72 /.73 /.76 /.77 /.78 /.79 /.80 /.99
5 ASSEMBLY
To achieve the highest possible accuracy, we recommend grinding the magnetic chuck on the machine where it will
be used, using the following procedure:
1. Grind the base plate without clamping the device to obtain a reference surface when the magnetic chuck is
released. To avoid sliding of the magnetic chuck during the back-and-forth movement of the machine table, it is
sufficient to attach 1 or 2 stops at each face side.
2. Turn over the magnetic plate and clamp it to the machine table. For relatively short devices that are only at-
tached to the face sides, we recommend tight clamping on one side and only very light clamping on the other
side. This provides for a potential relative expansion in longitudinal direction between the magnet and the
machine table.
3. Leave the magnetic chuck switched on for 30 to 45 minutes at normal coolant temperature with the workpiece in
place, so the magnetic chuck can stabilise. Pre-machine workpieces if applicable.
4. Always grind the pole plate of the magnet while magnetised to achieve a perfectly level pole plate under normal
conditions.
Summary of Contents for SAV 220.76
Page 75: ......
