i
LIMITED WARRANTY
The manufacturer offers the customer an 24-month functional warranty on
the instrument for faulty workmanship or parts from date of dispatch from
the distributor. In all cases, this warranty is valid for 36 months from the
date of production. This warranty is on a return to factory basis.
The manufacturer does not accept liability for any damage caused by
instrument malfunction. The manufacturer accepts no responsibility for
the suitability of the instrument to the application for which it was
purchased.
Failure to install, set up or operate the instrument according to the
instructions herein will void the warranty.
Your instrument may be opened only by a duly authorized representative
of the manufacturer. The unit should only be opened in a fully anti-static
environment. Failure to do so may damage the electronic components
and will void the warranty.
NOTE
The greatest care has been taken to manufacture and calibrate your
instrument. However, these instructions do not cover all possible
contingencies that may arise during installation, operation or
maintenance, and all details and variations of this equipment are not
covered by these instructions.
For additional information regarding installation, operation or maintenance
of this instrument, contact the manufacturer or your local representative or
distributor.
IMPORTANT
Please read the instructions this manual before performing
installation, and take note of the following precautions:
Ensure
that all incoming AC power and other power sources are
turned OFF before performing any work on the instrument. Failure
to do so may result in serious or even fatal injury and/or equipment
damage.
Before
connecting the instrument to the power source, check the
labels on the
side of the instrument to ensure that your instrument is
equipped with the appropriate power supply voltage, input voltages,
currents and communication protocol for your application.
Under
no circumstances should the instrument be connected
to
a power
source
if it is damaged.
Summary of Contents for PM130E
