SARGENT & GREENLEAF
■
WWW.SARGENTANDGREENLEAF.COM
[t] 800.826.7652
■ 859.885.9411 ■
E-mail: (Information Required)
■
One Security Dr. Nicholasville, Kentucky 40356
S&G TOUCHLESS ADO.docx REV - 08/2021
6
The motor assembly is mounted to a short aluminum “drive plate”. It is secured to the slotted housing back
plate using FIVE hex head bolts. Four (4) of the bolts secure the drive plate. The 5th bolt is fixed, and is used
to correctly position the drive plate into the housing using a ‘keyhole’ configuration. The keyhole allows for
easy removal of the drive plate without the need to loosen the 5
th
bolt. Removing the four (4) bolts allows the
drive plate & operator to be removed from the header and, if required, rotated 180 degrees to change from a
push to a pull or vice versa.
TO REMOVE THE MOTOR ASSEMBLY:
Disconnect the ON-Auto-OFF connector from the I/O board (plugs in below terminal 19)
Unplug the molex main power connector (green, brown, blue wires).
Next, locate & loosen the 4 side hex bolts (see above) using a 5mm allen wrench.
Slide the bolts away from the motor drive assembly allowing the assembly to be removed. The drive plate will
be held in place by the 5
th
hex bolt.
Summary of Contents for Touchless ADO
Page 1: ......
