SARGENT & GREENLEAF
■
WWW.SARGENTANDGREENLEAF.COM
[t] 800.826.7652
■ 859.885.9411 ■
E-mail: (Information Required)
■
One Security Dr. Nicholasville, Kentucky 40356
S&G TOUCHLESS ADO.docx REV - 08/2021
26
•
The pull arm assembly is a fixed dimension and is not adjustable in length. The slide block and pull
arm come pre-assembled from the factory.
•
Attach the spindle to the pull arm:
Insert the large hex bolt and washer into the 20mm
spindle adaptor
Then, horizontally slide the adaptor
onto the primary arm until the two
mounting holes of spindle line up
with the corresponding holes on the
primary arm. The spindle is intended
to fit tightly. Secure the spindle
using the two small hex bolts
BUT
DO NOT OVERTIGHTEN
•
To install the pull arm, the operator must be powered to the full open position, as it is not possible
to install the arm in the closed position as to allow proper preload.
•
Power the door to the open position through the use of the hold-open switch on the side of the
header. It may be necessary to first execute a “setup” on the operator prior to doing this. Refer to
the first step on Steps 5 & 6 for proper instruction.
•
Once the operator is rotated to the full open position, manually move the door to the desired full
open position and insert the slide track guide block into the track. Release the hold-open switch.
When completed, the end caps to the track can be installed.
•
Once the arm is installed and door is closed, press and hold button SW1 to launch a new setup (see
Step 6)
Summary of Contents for Touchless ADO
Page 1: ......
