SARGENT & GREENLEAF
■
WWW.SARGENTANDGREENLEAF.COM
[t] 800.826.7652
■ 859.885.9411 ■
E-mail: (Information Required)
■
One Security Dr. Nicholasville, Kentucky 40356
S&G TOUCHLESS ADO.docx REV - 08/2021
25
Auto Operator
Hinge
DOOR
Auto Operator
DOOR
7.5”
8”
Pivot
HINGE HUNG
CENTER
PIVOTED
Inside face of jamb to back edge of
slide track
Inside face of pivot jamb to spindle
Inside face of pivot jamb to back
edge of slide track
7.5"
10.5"
8"
HINGE HUNG DOORS
CENTER PIVOTED DOORS
PULL APPLICATION
•
With the door closed, the secondary arm should be at
approximately 90 degrees to the face of the door as
shown - it is not imperative that the arm be at this
"exact" position
•
Upon final installation of door arm assembly, press SW1
to launch a new setup - this is required for the control to
learn the new door stroke. Refer to Steps 8 & 9, Power On & Tune In Sections for more
information.
•
Upon successful completion of setup, proceed with remainder of installation .
PULL ARM INSTALLATION:
•
Ensure the main power supply is removed or shut off at the control.
•
Install the slide track assembly to the door at the specified location.
•
When using the standard 20mm spindle, the center of the track should be approximately 2-1/4”
below the operator header. Attach the track with the screws provided.
Summary of Contents for Touchless ADO
Page 1: ......
