SARGENT & GREENLEAF
■
WWW.SARGENTANDGREENLEAF.COM
[t] 800.826.7652
■ 859.885.9411 ■
E-mail: (Information Required)
■
One Security Dr. Nicholasville, Kentucky 40356
S&G TOUCHLESS ADO.docx REV - 08/2021
2
IMPORTANT
READ THIS SECTION BEFORE PROCEEDING WITH INSTALLATION
Sargent & Greenleaf (hereafter referred to as “S&G”) recommends that its automated pedestrian door
products be installed by a trained automatic door technician and that the resulting performance of the
product be in full compliance with the most current version of the American National Standards Institute
(ANSI) document A156.19 as well as any applicable building codes and/or fire codes. S&G further recommends
that a full inspection of the operating system be performed in accordance with the guidelines of the American
Association of Automatic Door Manufacturers (AAADM). S&G recommends this documented inspection be
performed upon completion of the installation, as well as following the completion of every service call
thereafter. If service is not performed within one year of the previous service action, a routine AAADM
inspection should be performed and documented. S&G does NOT recommend service on any of their
automated pedestrian door products, by any individual who is not certified as an AAADM inspector.
Following the installation or service of any S&G automated pedestrian door product, if it is deemed unsafe, or
is operating in an unsatisfactory manner according to national performance standards or recommended
performance guidelines as defined by S&G, repairs should be made immediately. If an immediate repair
cannot be made, the product should be disabled, and appropriate measures should be taken to secure the
door in a safe position or to enable the door to safely be used manually. During this situation, every effort
should be made to notify the owner (or person responsible) of the condition and to advise on corrective
actions that must be taken to return the product to safe operation.
LOW ENERGY APPLICATION NOTE
When using the
Touchless ADO
, S&G recommends the use of a door-mounted presence sensor on the
approach side of the door to be used as a secondary activation device. This type of sensor can be installed at
time of installation or can also be retrofitted. This device serves to re-activate the door to the open position
should a person enter into the closing path at the approach side of the door, as it is closing. Once the door is
fully closed, a "knowing act" device must then be used for initial activation. S&G considers this device to be
essential in reducing the possibility of doors "timing out" and closing before all pedestrians have passed
though the doorway.
Summary of Contents for Touchless ADO
Page 1: ......
