SARGENT & GREENLEAF
■
WWW.SARGENTANDGREENLEAF.COM
[t] 800.826.7652
■ 859.885.9411 ■
E-mail: (Information Required)
■
One Security Dr. Nicholasville, Kentucky 40356
S&G TOUCHLESS ADO.docx REV - 08/2021
35
Adjustment Board Indicators
Upon applying power, observe the above LED’s.
NORMAL OPERATION: DL3 will come on steady and then begin flashing after a few seconds.
FAULTY OPERATION; DL2 will be flashing red. This indicates…
•
An error condition exists – correct as necessary
•
Operator requires setup – launch a setup and proceed accordingly
NOTE: DL4 will illuminate yellow anytime a change has been made to the control, such as a speed or
time adjustment. Momentarily press on SW1 to acknowledge the change and extinguish the yellow LED.
Description
ON
OFF
1
Closed Door Force Additional force applied while door
is in closed position. Be sure to
maintain ANSI compliance if using
on low energy application. Cannot
exceed 30 lbf to get door moving
from jamb.
Disabled (Default)
2
Push / Pull Arm
Use for Slide Arm Applications.
Operator stroke at 90
°
degrees or
less. Visible change in performance
may not always be noticeable.
Push Arm Application.
Operator stroke 90
°
or
greater. (Default)
3
Night Function
(Exit Only)
Allows activation at input 10 when
On-Off switch is in OFF (night
function) position.
Disabled. The On/Off
switch, when OFF, requires
manual operation of the
door. (Default)
4
Push and Go
Enabled
Disabled (Default)
5
Full Power / Low
Energy
Low Energy performance enabled.
5 seconds to open, 7 seconds hold
open, 5 seconds to close. Speed &
time potentiometers are disabled.
Settings are fixed.
Disabled. Control can be
adjusted for full power or
low energy operation via
potentiometers. (Default)
6
Not used for Low
Set to OFF for Low Energy
DL1 : GREEN WHEN USB CONNECTION PRESENT
DL2: FLASHING RED LED
DL3: BLUE 5V POWER SUPPLY
DL4: BOARD VALUES DIFFER FROM DIP SWITCHES
(PRESS SW1 MOMENTARILY TO EXTINGUISH YELLOW LED)
Summary of Contents for Touchless ADO
Page 1: ......
