10
PREPARATIONS BEFORE OPERATING
WARNING
・ MAKE THE FOLLOWING PREPARATION BEFORE OPERATING
Complete items 1, 2.1, 3, 4 and 5.1 before connecting the air hose to the
compressor.
・ MAKE SURE THAT THE GRIP BAR IS SCREWED IN FIRMLY
Whenever the polisher is turned ON, i.e. in test for switch function ( item 7, page
13 ), test run ( item 9, page 13 ) and polishing operation ( HOW TO POLISH in
page 15 ), make sure that the grip bar is screwed in firmly.
1. MOUNT THE GRIP BAR
Firmly mount the grip bar ( see page Figure 2, 3 and 4, page 6 and 7 )
2. THE PROCEDURE TO MOUNT AND DEMOUNT THE WATER-SPLASH SKIRT
2.1 MOUNTING OF THE WATER-SPLASH SKIRT
Attentive point : The purpose of water-splash skirt is only to decrease water
splash from the water spray nozzle. As this water-splash skirt
is elastic and not strong enough, this does not work as a guard.
(1) Select a proper size of water-splash skirt according to TABLE 1 in page 6
(2) Install the water-splash skirt on the polisher body while expanding the
clamping mouth ( see Figure 4, page 7 ) of water-splash guard from inside
with fingers so that the clamping mouth fits onto the circumference groove
( see Figure 2, page 6 ) on the polisher body
3. PREPARE THE POLISHER
CAUTION
・ CHECK FOREIGN PARTICLES
Foreign particles in the motor could cause rotating failure of the motor. Therefore,
when connecting the air hose to the compressor, be careful not to let any dust,
small stone, etc, into the motor.
Securely fit the flexible water hose, the air hose and the exhaust air duct hose.
Failure to follow this instruction causes the disconnection and whipping of the
horses and finally injuries.
・ BE CAREFUL NOT TO DAMAGE THE AIR HOSE AND THE WATER HOSE
The polisher body, the air hose and the water hose are disconnected when shipping.
Connect these together as illustrated in Figure 6 in page 11.
2.2 DEMOUNTING OF THE WATER-SPLASH SKIRT
(1) Demount the flexible polishing pad and the spacer
(2) Pull out the water-splash skirt by hand
Summary of Contents for PA-2
Page 2: ......