18
･ USE DESIGNATED PARTS IN THIS INSTRUCTION MANUAL
Use only the parts shown in this instruction manual when accessories are
replaced.
WARNING
･ EXECUTE AN ADEQUATE MAINTENANCE
Remove dust from the polisher and keep it clean. Particularly take good care to
protect the connections with the compressor and polisher from contamination of oil
except ISO-VG46 or DIN51502DL46, water and dust.
･ HANDLE THE AIR HOSE WITH GOOD CARE
Do not carry the polisher with its air hoses, flexible water hose and exhaust air
duct in hand and do not add any tension to these hoses and duct. Doing so
would cause damage of these hoses and duct. Furthermore, be away from heat,
oil and article with sharp edge.
CAUTION
・
AFTER USE
1. DISCONNECT THE AIR HOSE
(1) Close the stop-valve on the compressor
(2) Turn OFF the polisher by switch lever
(3) Disconnect the air hose and exhaust air duct hose
(4) Disconnect the flexible water hose from water source
The flexible water hose does not need to be disconnected from the polisher body
2. EXECUTE AN ADEQUATE MAINTENANCE
Execute an adequate maintenance, referring MAINTENANCE AND CHECK in page 19
3. STORE THE POLISHER AT SAFE, CLEAN AND DRY PLACE
After cleaning out dust and mist from the polisher, store it at safe, clean and dry
place.
Furthermore, do not store it at the following places;
- where children reach or take it easily
- where temperature and humidity fluctuate rapidly
- where the polisher is exposed to rain or high humidity
- where the polisher is exposed to direct sun ray
Summary of Contents for PA-2
Page 2: ......
