11
Procedures:
(1) Connect the water hose. For this procedure, warm up the joint part of the flexible
water hose in hot water to facilitate the joint work.
(2) Guide the hose joint ( female ) through the air hose in advance and tighten it.
The required tightening torque is approximately 15 N m ( 1.53kg m ).
After tightening, ensure that the air hose is not disconnected even if adding
tension load thereto.
(3) Insert the exhaust air duct hose in the end case and clamp it with the hose clamp.
Figure 6 Connections of Hoses
4. TAKE NECESSARY MEASURES
In terms of environment, health and safety codes, take the necessary measures properly
when operating the polisher, referring to DECLARATION in page 1.
Exhaust Duct
( Upper )
Hose Nipple
End Case
Hose Joint
( Male )
Air Hose
Flexible Water Hose
Exhaust Air Duct Hose
Hose Clamp
Hose Joint
( Female )
Summary of Contents for PA-2
Page 2: ......
