SANEI ELECTRIC SK1-21A, Technical Manual

Page: 52 / 56

５２
SK1-21A/31A
6
．
Bit Image Command
Command Standard mode Page mode
ESC * Specify the bit image
GS * Register the downloaded bit image
GS / Print the download bit image
DC2 V Specify the high-speed bit image
DC2 v Print pressed rasta bit image
ESC b Specify the high-speed bit image with indicated printing width
7
．
Page Mode Command
Command Standard mode Page mode
ESC L Select the page mode
（
Invalid
）
ESC S
（ Invalid ）
Select the standard mode
ESC FF
（
Invalid
）
Print all page mode memories.
CAN Erase the print buffer Clear page mode memories
ESC T
（
Invalid
）
Select printing direction and initial position
ESC W
（ Invalid ）
Defining the print area
8 ． Peripheral Equipment Command
Command Standard mode Page mode
ESC = Select peripheral
ESC c 3 Select paper sensor to output PE signal
ESC c 5 Specify or cancel panel switch
ESC c 6 Enable / Disable paper loading
ESC i Full cut
ESC m Partial cut
GS V Paper cut
9. Response Command
（
Installed in Serial interface
）
Command Standard mode Page mode
GS a
Valid / Invalid of automatic status transmission
GS r
Transmit status
GS DLE
Valid/Invalid of real-time status transmission
GS EOT
Transmit status in real-time
GS E Answer the string
GS R1 Check printer status
GS R 3 Print start /cut end automatic status transmission
GS I Send printer ID
ESC s Send a printer information
ESC v Send a printer status in the present
10 ． Printing Image Registration Command
Command Standard mode Page mode
FS Q Specification of image registration onto the nonvolatile memory
FS R Cancel Image registration in the nonvolatile memory
FS O Set printing image registered in the nonvolatile memory
FS P Cancel printing image registered in the nonvolatile memory