SANEI ELECTRIC SK1-21A, Technical Manual

Page: 34 / 56

３４
SK1-21A/31A
(2 ） INTERFACE SETTING
Menu Default Value Description
SELECT
NEAR-END ON ON
OFF
Select near end sensor
ON ･･･ activate sensor
OFF
･･･
cancel sensor
CUT AFTER
FEED SW NON-CUT NON-CUT
PARTIAL-CUT
FULL-CUT
Select cutting operation after FEED switch is ON.
* function added after V1.20
USB DEVICE
CLASS PRINTER PRINTER
COMMUNICATION
Selects device operation mode of USB
* function added after V1.20
USB PORT
NUMBER NON NON
1-9
Select USB Port Number
・ NON ･･･ Selects arbitrary USB Serial ID
・
1-9
･･･
Selects USB Serial ID 1-9
* function added after V1.91
COMMAND
MODE MODE-A MODE-A
MODE-B
Select command emmuation
* function added after V1.20
BEZEL MODE
NON NON
MODE-A
MODE-B
MODE-C
Select bezel mode
* function added after V1.30
SELECT
REELER OFF OFF
ON
Select reeler mode
* function added after V1.51
PRESENTER
MODE CLAMP/
RETRACT CLAMP/RETRACT
CLAMP/EJECT
CLAMP ONLY
CONTINUOUS
Backward collecting operation
Forward collecting operation
Ejecting operation
Continuous ejecting operation
* function added after V1.89
Act. For Driver INVALID INVALID
VALID
Set driver’s activity
.
* function added after V1.99
Menu Default Value Description
BAUD RATE 115200bps 1200bps
2400bps
4800bps
9600bps
19200bps
38400bps
57600bps
115200bps
Select the baud rate.
BIT LENGTH 8bit 8bit
7bit Select the bit length of serial communication.
PARITY Non Non
Odd
Even
Select the parity of serial communication.
BUSY
CONTROL RTS/CTS RTS/CTS
Xon/Xoff
Select the flow control of serial communication.
CTS
AVAILABLE INVALID INVALID
VALID
Select the CTS signal of the serial communication
INVALID
・・・
CTS signal is invalid.
VALID
・・・
CTS signal is valid.
* function added after V1.99