Sandel ST3400H HeliTAWS, Installation Manual

Page: 20 / 112

2.3 Pre-installation Planning
The installation planning steps are summarized as follows:
1) Confirm the aircraft model is listed on the Approved Model List Supplemental Type
Certificate (AML STC). See section 10 for the AML STC details.
YES
Go to step 2.
NO
Contact Sandel Avionics for guidance. Additional FAA approval will
be required.
2) Identify mounting location on instrument panel. Is the intended location listed in section
4.3.4 of this Installation Manual?
YES
Go to step 3.
NO
Contact Sandel Avionics for guidance. Additional FAA approval may
be required.
3) Determine that the aircraft has the minimum required sensors & equipment See section
2.2.1 of this IM.
YES
Go to step 4.
NO
The ST3400H cannot be installed.
4) Compile an equipment list for the helicopter. Complete Installation Worksheet.
Worksheet can be found at:
http://www.sandel.com/st3400h/st3400h-support .
Determine that the sensors to be interface to the ST3400H are supported / approved.
Reference Section 8 (Sensor Compatibility)
YES
Go to step 5.
NO
Contact Sandel Avionics for guidance. Additional FAA approval may
be required.
82046-IM-K ST3400H INSTALLATION MANUAL Page 2-2