background image

Covered Bridge

72-4117-250

3/14

C

ongratulations on your purchase of the Lionel Covered Bridge! Lighted by three lamps, 
the Covered Bridge is easy to assemble. This accessory is capable of accommodating O-27 

gauge, O gauge, and FasTrack track sections.

Use a small Phillips-head screwdriver to assemble the structure.

Covered Bridge Inventory

Metal base
Roof
Roof vent section
Ends (2)
Side panels (2)
Lamps (3)
Washer screws (28)

The following Lionel marks are used throughout this Owner’s Manual and are protected under 
law. All rights reserved.

Lionel

®

, LEGACY

, FasTrack

®

,

 

TrainMaster

®

, Odyssey

®

, RailSounds

®

, CrewTalk

, TowerCom

DynaChuff

, StationSounds

, Pullmor

®

, ElectroCoupler

, Magne-Traction

®

, CAB-1

®

 Remote 

Controller, American Flyer

®

, Lionel ZW

®

, ZW

®

, MagniVision

®

, TMCC

®

, Lionelville

®

, Wireless 

Tether

, Powerhouse

, LionMaster

®

, Conventional Classics

, Postwar Celebration Series

TruRail

, PH-1 Powerhouse

®

, Powermaster

®

, Powerstation-Powerhouse

®

, Accessory Motor 

Controller

, AMC

, Accessory Switch Controller

, ASC

, Action Recorder Controller

, ARC

, Track 

Power Controller 300

, TPC 300

, Track Power Controller 400

, TPC 400

, Block Power 

Controller

, BPC

, Operating Track Controller

, OTC

, FatBoy

, Lionel Lines

®

, Joshua Lionel 

Cowen Series

, Lockon

®

, TrainSounds

, MultiHorn

, MultiWhistle

, Choo-Choo

, Sensor Track

Summary of Contents for 72-4117-250

Page 1: ...l rights reserved Lionel LEGACY FasTrack TrainMaster Odyssey RailSounds CrewTalk TowerCom DynaChuff StationSounds Pullmor ElectroCoupler Magne Traction CAB 1 Remote Controller American Flyer Lionel ZW ZW MagniVision TMCC Lionelville Wireless Tether Powerhouse LionMaster Conventional Classics Postwar Celebration Series TruRail PH 1 Powerhouse Powermaster Powerstation Powerhouse Accessory Motor Cont...

Page 2: ...the roof using four washer screws two at each end 2 Feed the wires between the posts on the roof section and the edge of the roof Run the wires toward the left side of an end opening 3 Install the sides using ten washer screws Be sure that the sides trap the wires at the roof and in the slots next to the opening 4 Attach the metal base to the ends and the sides using 14 washer screws Figure 1 Brid...

Page 3: ...re 2 connect one wire from each lamp to the Power A terminal on the transformer the 1 terminal on the Lockon or to one of the FasTrack Accessory Power Wires On FasTrack layouts we recommend that you use wire nuts available at electronics supply stores to make the Accessory Power Wire connections Twist the bare ends of the wires together then screw the wire nut over the connection 2 Attach the rema...

Page 4: ...u This warranty gives you specific legal rights and you may have other rights which vary from state to state Instructions for Obtaining Service If service for this Lionel LLC product is required bring the item along with your DATED sales receipt and completed warranty information at the bottom of this page to the nearest Lionel Authorized Service Station Your nearest Lionel Service Station can be ...

Reviews: