9
4. Setup
GX-101 currently provides 13 commands for setup. You can setup the GX-101 by following the instructions
shown in this chapter via SMS from a cellular phone. Key the specific SMS message in your cellular phone as
the instruction and send it to the SIM number of GX-101. The setup messages are showed in the following
sections.
Note1: The default settings are shown as below.
a. Default GX-101 ID is “username”, and please read Chapter 5.1 in order to change the ID.
b. Default password is “0000”, and please read Chapter 5.2 in order to change the password.
c. There’s no number in the default contact, and please read Chapter 5.5 in order to add the phone
number.
d. Default setting of Auto Report is deactivated, and please read Chapter 5.6 in order to setup the auto
regular report.
e. Default setting of APN is only suitable for Taiwan GSM network and please read Chapter 5.3 in order
to change the APN.
f. Default setting of IP/domain is
http://www.sanav.com/eric-gga/gprs.aspx
and please read
Chapter 5.4 in order to change the IP/domain.
g. Please be aware of the upper and lower cases when you send the SMS command to GX-101.
Note2: Before doing any setup, please ensure GX-101 is connected with the GSM network. The red LED must
lights on. And please note that GX-101 must not be under Panic mode.
Note3: While you are keying in any setup message, note that NO space is allowed between the characters in
the SMS. Characters can be letters, commas or any signs.
Note4: Any setup message must be started with a “#” sign and ended up with a “*” sign.
Note5: Only when the password, username and setup message are correct, the GX-101 will update information
according to user’s definition. If the command is not valid, a failure report is going to be sent to the
commander cell phone.
