SUPPLEMENTAL
Argus Installation and Resource Guide
26
6.0
SUPPLEMENTAL
6.1
DETECTOR INSTALLATION GUIDE
Instructions:
Read completely through these instructions before beginning installation.
1.
Using the following three pages, determine the number of detectors needed
corresponding to your pipe diameter.
Note
: These numbers are specific to cotton gins, consult factory for non-gin applications.
2.
Lie out a length of string cut to the length of the pipe perimeter and mark the string by
lengths of the perimeter divided by the number of detectors determined from step 1. The
ends of the string represent one detector.
Example: I have a 24” diameter pipe so I will have 5 detectors. My string length will be
about 75 inches on which I will place a mark every 15 inches (75/5) along the length of
the string.
3.
Wrap the string around the pipe and transfer the marks on the string to the pipe. These
marks are where the template in following step will be centered. Important: Detectors
should not be placed at the bottom of horizontal pipes. Place marks such that detectors
are as far from the bottom of horizontal pipe as possible. Note: Try to locate the
detectors near an access door into the pipe to facilitate installation and enable easy
maintenance. The access must be light tight for proper operation.
Summary of Contents for Argus
