Bellman Visit System Information
Page 23
Technical Solutions 2005/06
Function
The BE1345 Bellman Visit Alarm Clock is a combined alarm clock
and receiver within the Bellman Visit System for indoor use, which
draws the attention of the user with a flashing light, noise and
one or two BE1270 Bed-shakers (accessory). It is activated by the
clock’s alarm, radio signals from transmitters within the Bellman
Visit System, connection to an external trigger input or via direct
connection to a telephone socket. The snooze function delays the
alarm call for approximately 3.5 minutes and will ignore the external
trigger indicator (17) and telephone indicators from the telephone
connection (19) for up to 45 seconds.
Installation & connection
The unit is usually placed vertically on a level surface
The Bellman Visit Alarm Clock is connected to mains power via the
power supply unit supplied. The Bellman Visit Alarm Clock must
first be connected to mains power for at least 24 hours in order to
operate correctly. For further information see Charging.
The unit is connected to the Bellman Visit System by radio. For
further information see Settings.
It is connected to the telephone via telephone input (19) with the
BE9105 Telephone cord (accessory) and an adapter plug.
An external trigger (17) can be connected to the vibrator output on
several Bellman & Symfon AB products or other equipment that
produces a contact or voltage for activation. For further details see
Technical information.
Testing
The Bellman Visit Alarm Clock must be connected to mains power
using the power supply unit supplied.
Test the flash light, sound and vibration with the BE1270
Bellman Bed-shaker (accessory):
•Turn the dial for Alarm Off/On (9) to position 1.
•Turn the alarm pointer anticlockwise until the clock alarm operates.
• The alarm clock will now flash and vibrate
(with accessory BE1270).
A Bellman Visit System transmitter is required to test
the radio reception.
• Press the transmitter test button.
• The Bellman Visit Alarm Clock will respond with a flashing light,
sound signal and vibrations (with accessory BE1270) and the LED
corresponding to the transmitter will light.
Two tests are required to test the external trigger; one to test contact
and another to test voltage. For further information see Technical
Information below. Please note that when the Snooze button is
pressed, the external trigger alarm will be ignored for up to 45 seconds.
• Connect the alarm unit to the external trigger (17) input.
• Activate the alarm.
• The Bellman Visit Alarm Clock will flash, sound and vibrate
(with accessory BE1270).
Bellman Visit Alarm Clock
BE1345
Technical information
Power supply
Mains power:
7.5 V DC / 500 mA with
battery eliminator BE9092 (Europe) and
BE9093 (United Kingdom).
Back-up battery:
Internal NiMh battery.
The internal back-up battery must be
changed at a service workshop.
Charging:
Via the power supply unit. The
discharged back-up battery will take at least
24 hours to charge.
Radio function
Radio frequency:
433.92 MHz
Number of channels:
64 logical channels
Coverage:
The normal coverage between
a transmitter and receiver in the Bellman
Visit System is approximately 80 metres
with a clear line of sight. Coverage is
reduced if walls and large objects screen
off the signal. Any thick walls constructed
of reinforced concrete will greatly affect
coverage.
