MP9311 User’s Guide
22
Modifying Tags
RF Command Suite can be used to modify previously programmed tag data. To
modify tags, perform the following:
1. Select the
Tag Summary
interface and right-click on the tag.
Figure 17–Select Tag to Modify
2. Select
Modify Tag
. The tag data window is displayed.
Figure 18–Modify Tag Option
3. Select the
Address
from the pull-down.
4. Enter the data
Length
and actual
Data
for the specific address
5. Select if
ASCII
data and whether or not there is a
Single tag in field
.
6. After all data and parameters are entered, press
Write
.
7. Repeat for each address.
Resetting the MP9311
To reset the MP9311, drive the reset line low for 3 ms. Refer to Chapter 5 -
Specifications
for detailed information for location of the reset pins on the system
connector (SCON1).
Summary of Contents for MP9311 Series
