Operation
21
Writing Blank Tags
RF Command Suite can be used to write unprogrammed or blank tags. To write
blank tags, perform the following:
1. Select the
Command
interface and verify the reader is connected and the
correct protocol is selected.
2. Place the reader in
Polled Read
mode.
3. Verify a single tag is in the RF field of the reader.
4. Select the
Tag Summary
interface.
5. Select the protocol from the pull-down above the
Write Blank Tag
button.
Figure 15–Select Tag Protocol
6. Press the
Write Blank Tag
button to begin the operation and
display the tag data box.
Figure 16–Write Blank Tag
7. Fill in the appropriate data (in Hex) and press the
Write
button to
write the data to the tag.
NOTE: For detailed information on the various tag protocols and how each protocol is
programmed, refer to
Appendix A –Tag Programming
.
Summary of Contents for MP9311 Series
