SAMSys MP9311 Series, User Manual

Page: 25 / 60

Operation
17
Enabling Tag Protocols
SAMSys readers can be configured with different tag protocols. If your reader was
loaded with specific protocols at the time of purchase, these protocols can be
enabled or disabled as required. To verify which protocols are enabled for your
reader, select:
Reader Configuration
D
General Configuration
D
Operating Mode
D
Protocol Select Word
To configure the reader for a specific protocol, perform the following:
1. Select the Protocol Select Word (PSW) parameters as shown in the following:
Figure 12 – Protocol Selection
2. Enable or disable a protocol by using the selectors on the right side of the
display and press
Send Changes to Reader
.
Configuring Specific Protocols
Individual Protocol Configuration registers can be modified for specific tag types
and read modes. For specific protocol configuration register information, refer to
the
Comprehensive Heuristic Uniform Messaging Protocol (CHUMP) Reference
Guide . To configure individual protocol registers, perform the following:
1. Select the individual protocol configuration word parameters.
Figure 13 – Protocol Parameter Configuration
2. Enable or disable a specific protocol parameter by using the selectors on the
right side of the display and press Send Changes to Reader .