(1) At the moment of selection of stop function, ice-making function stops, but on eject, return to
horizontality, and water-supply, stop state will be maintained after finish of water-supply.
(2) When OFF function is selected, ice-making function stops. If you push button to select CRUSHED ICE
or CUBE ICE, ICE-MAKER will continue to operate from the stop of ice-making. (This means that ice-
making function does not operate from the first.)
(3) In spite of operation of OFF function, ice LEVER will operate normally. This is not the disorder. So, ice
left in the tray of the ice-maker can be used normally. On operation of ice LEVER, GERADE MOTOR will
operate normally and CUBE ICE can be obtained. (On operation of OFF function, only CRUSHED ICE
can be obtained.)
(4) If you want CUBE ICE from the ice left in the tray during OFF function operation, push the button to
select CUBE ICE, obtain the ice and then, operate OFF function again.
3. WATER DISPENSER function
1) This function is directly connected to city water and water can be obtained from WATER SOLENOID
VALVE by pushing WATER LEVER.
Since there is no function regulated by MICOM PCB, if there is any problem with water dispenser function,
check solenoid, connector, and water-supply state.
Notice
With DOOR of freezer open, ice cannot be obtained. This is to prevent from dropping ice into floor
when DOOR of freezer opens and ice LEVER is pushed. Contact point in DOOR S/W is used as
sensor for opening state of DOOR of freezer. Water dispenser is operated normally regardless of
opening of DOOR.
24
23
