I
NSTALLING
A
N
ETWORK
O
PTION
A
.
10
Configuring Netware
On IPX/SPX protocol networks (for example, Novell NetWare),
the format of network communication frames must be specified
on the printer. In most cases, you can keep the default setting
on “AUTO.” However, you can manually set the frame type
format if required.
• AUTO (default): Automatically senses and limits the frame
type to the first one detected.
• IEEE802.3: Limits the frame type to IPX over IEEE 802.3
frames. All others are discarded.
• ETHERNET II: Limits the frame type to IPX over Ethernet
Frames. All others are discarded.
• IEEE802.2: Limits the frame type to IPX over IEEE 802.2 with
IEEE 802.3 frames. All others are discarded.
• SNAP: Limits the frame type to IPX over SNAP with IEEE
802.3 frames. All others are discarded.
Take the following steps to change the frame type format:
1
Press
Menu/Exit
and then
System Setup
on the one-
touch dial keypad. SCX-5115 users should press
Menu
and
then
Enter
.
2
Press
or
to display “NETWORK SETUP” on the top line.
3
Press
or
to display “CONFIG NETWORK” on the
bottom line.
4
Press
Mode/Enter
(
Enter
for SCX-5115) to access the
menu.
5
Press
or
to display “NETWARE” on the bottom line.
6
Press
Mode/Enter
(
Enter
for SCX-5115).
7
Press
or
to select the frame type you want to set and
press
Mode/Enter
(
Enter
for SCX-5115).
If you don’t want to enable the Netware protocol,
select “OFF”.
8
To return to Standby mode, press
Stop/Clear
.
Summary of Contents for SCX 5115 - B/W Laser - All-in-One
Page 59: ...PAPER HANDLING 3 10 NOTE ...
Page 73: ...COPYING 4 14 MEMO ...
Page 103: ...MAINTENANCE 7 12 MEMO ...
Page 123: ...TROUBLESHOOTING 8 20 NOTE ...
