Installation instructions
3.3.6
Setup of the upright appliances, e.g. Type 2011
.
Align the appliance horizontally to ensure that
water is optimally drained from the cooking cham
ber.
.
Check after aligning the unit whether the door
closing mechanism properly engages with the
door catch.
D
Risk of damage If not set correctly, the door
closing mechanism may hit the tip of the door
catch and damage it.
.
Install washers on the wheel attachments of the
rack trolley to align the trolley flush with the coo
king chamber.
D
The rack trolley must not brush against the seals
of the cooking chamber, and must have a uniform
distance on all sides.
D
The seal area of the rack trolley must lie flush
against the lower door seal to ensure closure.
.
Secure the appliance against movement.
.
Secure the front screw bases with the foot
clamps against turning.
3.3.7
Installing the compensation frame for Type 2011/2021 (option)
The compensation frame is required in order to com
pensate for the unevenness of the ground and to
ensure parallel entry into the cooking chamber.
Up to approx. 25 mm unevenness of the ground can
be compensated.
Kit compensating frame Item No. 881895: Suitable
for 881718 plate rack trolley, 880625 GN rack trolley,
879482 BN rack trolley.
Installing compensating frame
.
Use the screw feet and align the appliance hori
zontally
1. Remove the Allen screws from the clamps.
2. Push the clamps downwards over the retaining
tube.
3. Compensation frame not placed beneath the
appliance.
4. Push the clamps upwards over the retaining tube.
5. Use an Allen screw to fully tighten the clamps.
6. Horizontally align the compensation frame with
hexagon-headed bolts and lock using hexagon
nuts.
.
Check to make sure that the rack trolley can be
moved in parallel to the edge of the cooking
chamber.
Extend screw base max.
55 mm.
Base clamp
Door closing
mechanism
Door catch
Clamp, left
Clamp,
right
Retaining tube
Square tube
Square tube
1./5.
1./5.
2.
2.
3.
4.
4.
5.
5.
