![background image](http://html1.mh-extra.com/html/salvis/cucina-easy/cucina-easy_installation-instructions-manual_804154007.webp)
Installation instructions
3.3.4
Setup on tables and support structures
D
Use only support frames approved by the appliance manufacturer.
D
When setting up the appliance on countertops and work tables sufficient stability and load capacity
must be observed. Note the weight of the appliance, including the contents. For weight information, see
from page 16, Chapter 8.
D
Secure support frames and setup surfaces against tipping.
Safety notes and instructions for use for units on mobile table or rack
.
Setting up the unit of mobile tables or racks should be avoided for safety reasons! However, if the cu
stomer requests a mobile design, the following instructions on setup and use must be observed!
D
To protect power cables, secure the mobile table or rack with a safety chain! The safety chain must be
shorter than the power cable! Fasten the safety chain accordingly short.
D
The table or rack must be secured against rolling off during operation! Lock the parking brake at the
wheels! The appliance must not be moved during operation!
D
Move mobile tables or racks carrying units only on level surfaces! Do not drive over inclines or steps!
D
Before moving the unit remove vessels/food items from the unit, switch off the room's main switch, pull
the power plug, close the water shut-off tap, remove the water drain pipe and water supply hose, wind
up all supply lines and secure against falling down, disengage the parking brake on the wheels; caution
- danger of tipping: Move the table or rack carrying the unit carefully!
D
Check before each reconnection whether the electrical supply cables and hose connections are not
damaged! The unit must not be started if the supply lines are damaged!
3.3.5
Adjust screw bases, secure the appliance against movement, type 623, 611, 1011
D
Set up the appliance level. Compensate minor unevenness with the adjustable bases. Attention, note
maximum extension dimension!
D
Secure the appliance against movement.
Extend max. 5 mm.
Types 623
T
, 611
T
, 1011
T
Types 611
QT
, 1011
QT
Corner profile article
no. 878391
At least two items
required. Affix, for
example, diagonally
across to the table top.
Locking disk compl. article no. 880654
At least two items required. E.g. affix to the
table top for the front bases.
The setup face of the base
is perforated in the centre.
Punch out the perforation
to place on the locking
disk.
100 to max.
130 mm
Support
base article
no. 881166
120 to max.
180 mm
Standard
Optional