13
OwnersManual-TileSaw-CTC705-Rev11-2023
CTC70 Electrical
Motor Specifications:
Voltage:
115-volt
Cycles:
60Hz
Amperage:
15 Amp
Horsepower:
1 HP
Watts:
735 watts
Motor RPM:
18,000 RPM
Electrical Motor Specifications
Recommendations:
• It is recommended that a 15 AMP CIRCUIT be used while operating this saw, for best
performance use a 20 AMP CIRCUIT. This will prevent any loss of power or interruption.
• Always plug saw as close as possible to the power source while
operating. This will allow you to receive optimum electricity.
Extension Cords:
Most motor trouble
is the result of too small gauge or too long of extension cord.
Cords must be
one piece and as short as possible.
Cords should be no longer than shown on Table 3: Extension
Cord Maximum Length Chart (see above). Norton Construction Products is not responsible for
damage to motors due to the use of extension cords that are too small or too long.
Electrical Supply:
The CTC705 can only be used on a 115-volt 60 Hz 1 Phase circuit with a minimum of a 15-amp
breaker, for best performance use a 20-amp breaker.
Before connecting the CTC705 to the
electrical supply, make sure the voltage is 115v. Connecting the CTC705 to voltages higher
than may result in motor damage and is not covered under any warranty.
Generator:
Using the machine with a generator that is less than the recommend output can result in motor
damage and is not covered under warranty. Only use with a generator that is capable of continuous
put of 4,000 w (4kW) at 20 amps or greater.
Table 3. Extension Cord Chart
Wire Gauge
115V Max Length
12 AWG
25' (7.6 m)
10 AWG
50' (15.2 m)
8 AWG
75' (22.8 m)
ELECTRICAL
