10
OwnersManual-TileSaw-CTC705-Rev11-2023
Open the container, carefully lift the saw by the saw frame handles and place it on a flat, level
working area. Be certain that you have the following items before you discard the container.
• Saw
• Universal Wrench
• Polypropylene Water Tray
• Water Pump
• Ø7" Saw Blade
• Miter Block
• 45º / 90º Rip Guide
• Owner's Manual
Blade Guard Assembly
1. Remove the Blade Guard (1) and saw Blade package from the accessory box.
2. Lift the cutting head (2) from the insert style-foam that is designed to re-enforce strength to the
box.
3. Slide the cutting head through the rear support post’s shaft as shown in the lower diagram and
screw on the adjustment knob.
4. Slide the Blade Guard into the hex bolt (3) located at the rear of right side of the Electrical Control
Box (5) and fasten tightly using the knob screw (4).
5. Place the Ø7" blade onto the shaft, make sure that the directional arrow is pointing in the
direction of the shaft rotation. Lift up the Blade Guard, then fasten the blade tightly using the
outer Flange and Lock nut.
UNPACKING,
ASSEMBLY & SET-UP
