19
OwnersManual-TileSaw-CTC705-Rev11-2023
Miter Cuts
1. For miter cuts, place the lip of the miter block on the Ruler Guide, with the threaded
knobs facing you.
2. Tighten the threaded knobs to secure the miter block in place.
3. Place material onto miter block and you are ready to cut.
Cutting Depth
The recommended cutting depth is to have the bottom of the diamond blade approximately
¼" below the cutting table surface.
The CTC705 is designed with a 1-½” ~1-¾” clearance between the top of the cutting table
and the blade trough.
Warning: Only use either Ø6" or Ø7" blades for this saw. Using a smaller size diamond blade
may grab the material being cut instead of cutting it, causing damage and possibly injury.
OPERATION
