29
OwnersManual-TileSaw-CTC705-Rev11-2023
Bearing Housing installation
1. Remove the 4 screws on the belt guard (Attach to Belt Guard Bracket).
2. Remove the belt guard from Bracket.
3. Loosen the tighten screw from the end of blade's Pulley Shaft, remove the Belt from Pulley.
4. Remove the blade nut and the blade (if there is one present).
5. Remove the 4 screws on the cutting head to remove the bearing housing (including the inner
flange).
To install the new bearing housing:
1. Be sure that you have completed the instructions above to remove the old bearing housing.
2. Open the box and carefully place the flat portion of the new bearing housing face-down on a
towel situated on a flat surface.
3. Secure the cutting head in a completely horizontal position.
4. Slide the new Bearing Housing with the flat portion facing upwards onto the 4 screws located
below the Cutting Head. Do this carefully to avoid damage to the inner flange. Lock the bearing
housing into place by using brackets and nuts.
5. Place the Belt on the pulleys, and make sure the Pulley lock screw is tight correctly direct to the
key pin. Belt tightness has been pre-set. No adjustment necessary.
Warning: Do not adjust the Inner Flange that is attached the bearing housing from the original
package.
6. Replace the belt guard and lock into place using the 6 screws.
SAW MAINTENANCE &
TROUBLE SHOOTING
