Sagola X4100 Series, Instruction Manual

Page: 38 / 148

ENGLISH
10.2. Cleaning or replacement of the product filter
· Gravity/suction version:
If there is any cleaning liquid or product remaining in the tank, return it to its corresponding
containers. To avoid any spillage, keep the pistol in a vertical position and clean as thoroughly
as possible.
Holding the pistol firmly by the handle, disassemble the tank by unscrewing
it from the body of the pistol .
Extract the product filter (No.29) and if there is any cleaning liquid or
product remaining in the body of the pistol, return it to its corresponding
container.
Clean or replace the product filter as needed, taking into account that the impurities will cause
defects in the finish and/or obstructions..
Assemble the product filter again, inserting it all the way into the hole in the input connector.
Fit the tank by screwing it firmly onto the body of the pistol , to avoid product leaks.
Tighten the filler cap firmly.
In the version with the non-drip cap, tip it forward (paint up) or back (paint down) as necessary.
Check there are no leaks.
· Pressure version:
Holding the pistol firmly by the handle, disassemble
the racord to the product inlet and extract the
product filter .
Clean or replace the product filter as needed,
taking into account that the impurities will cause
defects in the finish and/or obstructions.
Assemble the product filter again, inserting it all
the way into the hole in the input connector.
Fig.14 Fig.15
Filter holder
Filters