Ryobi BCL3620 User Manual Download Page 10

Page: 10 / 131

Deutsch (Übersetzung der originalen Anleitungen)

English (Original instructions)

WARNING

Charge in a well ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.

CHARGING THE BATTERY PACK

Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them until the green LED on the front of the charger comes
on.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack
cool down for approximately 30 minutes before attempting
to recharge.

NOTE:

This situation only occurs when continuous use

of a tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to CHARGING
A COOL BATTERY PACK for normal recharging of
batteries. If the charger does not charge the battery pack
under normal circumstances, return both the battery pack
and charger to your nearest Authorized Service Center for
electrical check.

CHARGING A COOL BATTERY PACK

Only charge the Ryobi battery pack BPL3626 with this
charger. Make sure the power supply is normal household
voltage, 220-240 V, 50-60 Hz, AC only. Make sure the
battery pack latch snaps into place and the battery pack is
secured in the charger before beginning operation. Make
sure the power cord is fully seated in the charger socket.

1. Connect the charger to the power supply.
2. Place the battery pack in the charger aligning raised

rib on the battery pack with the groove in the charger.

3. Slide in the battery pack to be sure contacts on the

battery pack engage properly with contacts in the
charger.

NOTE:

After charging is complete, the charger LED

will remain on with green color until the battery pack is
removed from the charger or charger is disconnected
from the power supply. The battery pack will become
slightly warm to the touch while charging. This is
normal and does not indicate a problem. Do not place
the charger and battery pack in an area of extreme
heat or cold. They will work best at normal room
temperature.

NOTE:

The charger and battery pack should be placed

in a location where the temperature is more than 10°C
but less than 38°C.

4. When batteries become fully charged, unplug the

charger from the power supply and remove the battery
pack.
To remove the battery pack from the charger, depress

the battery pack latch.

BATTERY PROTECTION FEATURES

Ryobi 36 V lithium-ion batteries are designed with features
that protect the lithium-ion cells and maximize battery life.
If the tool stops during use, release the trigger to reset and
resume operation. If the tool still does not work, the battery
needs to be recharged.

WARNING

If at any point during the charging process none of the
LEDs are lit, remove the battery pack from the charger
to avoid damaging the product. Do not insert another
battery. Return the charger and battery to your nearest
service center for service or replacement.