7B
TRAMPOLINE MAT ASSEMBLY
Step 7 –Mat Assembly – Insert Cable Wires
A. Before attaching the springs, you first need to insert two cable wires into the underside of the mat. First
connect two sets of cable wires in the sequence shown below (i.e. connect Cable Wire A with Nut Cap (# N) to
Cable Wire A (# J), then to Cable Wire with Nut Cap (# K). Tighten Nut Cap with Wrench (# H) as shown below.
B. Insert the two sets of assembled cable wires through the loops sewn to the underside of Trampoline Mat (# 18)
as shown in FIGURE 15.
K
J
N
FIGURE 15
# 18
Loop
# 18
Cable Wire
22
Cable wire /
Kabelvajer /
Kabelvaier /
Kabeldraht /
Kaapelivaijeri
Loop /
Ögla /
Løkke /
Öse /
Silmukka
Insert the two sets of assembled cable wires
through the loops sewn on the bottom of the
trampoline mat. See step 7B. /
Sätt i de två uppsättningarna av sammansatta
kabelvajrar genom slingorna som sytts på
undersidan av studsduken. Se steg 7B. /
Sett inn de to sammensatte kabelvaiersettene
gjennom løkkene som er sydd på undersiden av
trampolineduken. Se trinn 7B. /
Setzen Sie die zwei Sets zusammengesetzter
Kabel-drähte durch die Schlingen, die an der
Unterseite des Sprungtuchs angenäht sind, ein.
Siehe Schritt 7B. /
Pujota kaksi koottua kaapelivaijerisarjaa
trampoliinin maton alapuolelle ommeltuihin
lenkkeihin. Katso vaihe 7B.
