Operation
74
Runco LS-10d and LS-10HBd Installation/Operation Manual
PRE
L
IMINAR
Y
Color
S
pace:
Select Color Space from the Service menu to choose the color space of
the source signal for HDMI, RGB, and component connections.
• The default setting,
Auto
, functions as follows:
•
HDMI:
If the Auxiliary Video Information (AVI) infoframe contains color space and/or
range data, the DHD Controller uses that information. Otherwise, for RGB sources,
the DHD Controller uses the
RGB-Video
color space. For component SDTV and
EDTV resolutions,
REC601
is used. For other component video resolutions,
REC709
is used.
•
RGB:
If Hsync or Vsync signals are present, the DHD Controller uses the
RGB-PC
color space. Otherwise,
REC601
is used for SDTV and EDTV sources, and
REC709
for all other sources.
•
Component:
For SDTV and EDTV resolutions, the DHD Controller uses the
REC601
color space. For all other resolutions, REC709 is used.
In most cases, the
Auto
setting determines the correct color space to use. If it does not,
you can force the DHD Controller to use a specific color space. Choose one of the
following:
•
REC709
sets the color space matrix to that defined in ITU-R BT.709.
•
REC601
sets the color space matrix to that defined in ITU-R BT.601.
•
RGB-PC
uses RGB color space and sets black at 0,0,0 RGB and white at
255,255,255 RGB, assuming an 8-bit image.
•
RGB-Video
uses RGB color space and sets black at 16,16,16 RGB and white at
235,235,235, assuming an 8-bit image, to correspond to the luminance values defined
in digital component standards.
Trigger
s
:
Select Triggers from the Service menu to configure the 12-volt trigger outputs.
You can assign one or more trigger outputs to each aspect ratio. Those triggers are then
activated by selecting that aspect ratio.
If your LS-10 is equipped with an anamorphic lens, assign at least one trigger output (the
same one to which the lens motor is connected) to the Cinema and Virtual Cinema aspect
ratios.
Mi
s
cellaneou
s
:
Select Miscellaneous from the Service menu to set the following options:
• Language:
Select Language from the Miscellaneous menu and press the up- or
down-arrows to select the OSD Language (English, Français, Deutsch, Italiano,
Español, Svenska,
(Simplified Chinese),
(Traditional Chinese),
Português,
(Russian),
(Japanese) or
(Korean)).
• O
S
D Timer:
Select OSD Timer from the Miscellaneous menu to set the OSD Timer,
which controls how long the menus remain on-screen after selecting them. Select from
5 to 60 seconds, in one-second increments. Or, set the timer to 0 (disabled) if you want
the menus to remain on-screen indefinitely.
• O
S
D Me
ss
age
s
:
When you select a new aspect ratio, input source or memory preset,
the DHD Controller briefly displays an on-screen message confirming your new
selection. To prevent the display of these messages, select OSD Messages from the
Miscellaneous menu to and set it to
Off
.
• Blan
k
S
creen Color:
Select Blank Screen Color from the Miscellaneous menu to
select the color that appears when no incoming signal is present. The range is from 0
to 255 inclusive for each color component (red, green and blue).
Summary of Contents for LIGHTSTYLE LS-10D
Page 2: ......
Page 10: ...x Runco LS 10d and LS 10HBd Installation Operation Manual P R E L I M I N A R Y Notes ...
Page 125: ......
