Runco LIGHTSTYLE LS-10D, Installation & Operation Manual

Page: 82 / 126

Operation
66 Runco LS-10d and LS-10HBd Installation/Operation Manual
PRE
L
IMINAR
Y
• Noi s e Filter: To apply noise filtering to the input signal, select Noise Filter from the
Input Color menu. The Noise Filter is useful for clearing up noisy images from 480i
video sources.
Use the left- or right-arrow buttons to select the desired amount of noise reduction,
keeping in mind that higher settings (which reduce high frequencies) may also “soften”
the image.
S ave I S F Night/ S ave I S F Day: Whenever you make a change to the ISF settings, you
should always save it. Select Save ISF Night or Save ISF Day from the Calibration menu to
do this.
Copy/Pa s te - Memory Pre s et: You can copy and paste settings from one memory
preset to another. This gives you a convenient starting point for creating a new preset
based on an existing one, to make the calibration process less time-consuming.
For example, you can use the Copy/Paste Memory Preset feature to:
• Apply settings from HDMI 1 to HDMI 2, or from HD1 to HD2.
• Calibrate an input for 720p source signals, then use those settings for 1080i sources.
• Duplicate ISF Night settings for a given source and signal format and save them in the
Custom 1 memory preset.
To use this feature, select Copy/Paste from the Calibration menu, then select Memory
Preset.
• Memory Pre s et - Copy S etting s : Select Copy Settings from the Copy/Paste
Memory Preset menu to place the settings for the current input source, signal format
(resolution and frame rate) and memory preset onto a “clipboard,” which is a temporary
memory location. When you do, the message “Settings Copied” briefly appears
on-screen. The Copy/Paste menu then re-appears, indicating the source of the copied
settings.
• Memory Pre s et - Pa s te S etting s : To apply the settings on the clipboard to a
different input source, signal format and/or memory preset, do any or all of the
following:
• Switch to another input (for example, from HD1 to HD2).
• Change the output signal format at the source (for example, from 720p/60 to
1080i/60).
• Switch to another Memory Preset (for example, from ISF Night to Custom 1).
Then, select Paste Settings from the Copy/Paste Memory Preset menu. If you want
to keep these new settings, you must save them! (Refer to Save ISF Night/Save
ISF Day on page 66 or Memory Presets on page 58.)
Copy/Pa s te
Memory Preset
Aspect Ratio
Memory Pre s et
Copy Settings
Paste Settings
Copied From:
Input Source HDMI 1
Signal Format 1080p/60
Memory Preset ISF Night
Copied settings are not retained after a power cycle.
Note